Instructions / Assembly

BOLT

3-1/2"

CARRIAGE

SWING BEAM PLATE

3/8" WASHER

3/8" LOCK NUT

BOLT CAP

STEP 27: SWING BEAM PLATE

1: PLACE THE SWING BEAM PLATE ON TOP OF THE SWING BEAM SUPPORT, LINING UP THE PILOT HOLES.

2: FASTEN THE SWING BEAM PLATE TO THE SWING BEAM SUPPORT USING 3-1/2" CARRIAGE BOLTS ON TOP AND 3/8"

LOCK NUTS WITH 3/8" WASHERS FROM UNDERNEATH, IN THE COUNTERBORED HOLES OF THE SWING BEAM SUPPORT.

USE BOLT CAPS TO COVER ANY EXPOSED THREADS.

3: LEAVE THE MIDDLE HOLE EMPTY, IT WILL BE USED LATER.