Instructions / Assembly

STEP 25: SWING BEAM TO FORT
*AN EXTRA PERSON IS REQUIRED FOR THIS STEP
1: LINE UP THE PILOT HOLE ON THE END OF THE SWING BEAM WITH THE MIDDLE HOLE ON THE SWING BEAM PLATE.
2: FASTEN THE SWING BEAM TO THE SWING BEAM PLATE AND SWING BEAM SUPPORT USING A 9" CARRIAGE BOLT
WITH TORQUE WASHER ON TOP AND A
3
8
" LOCK NUT AND
3
8
" WASHER ON THE BOTTOM. PLACE GREEN BOLT CAPS
OVER EXPOSED THREADS AFTER SECURING.
3: FASTEN THE SWING BEAM TO THE SWING BEAM PLATE FROM UNDERNEATH WITH A 3
1
2
" LAG SCREW AND
3
8
"
WASHER.
8
BOLT CAP
3
" WASHER
8
3
8
" WASHER
3
" LOCK NUT
3
1
2
"
LAG SCREW
9" CARRIAGE BOLT
TORQUE WASHER
50