Instructions / Assembly

COUNTERBORED
HOLES FACING
OUT
DOWN
HOLES FACING
COUNTERBORED
4 X 4 X 44"
SWING BEAM
MOUNT
ARM
A
TRAPEZE
SWING BEAM MOUNT
B
VIEW OF LEFT SIDE OF PLAY SET
STEP 19: SWING BEAM MOUNT AND TRAPEZE ARM
VIEW OF RIGHT SIDE OF PLAY SET
1: THE 4 X 4 X 44" SWING BEAM MOUNT HAS COUNTERBORED HOLES IN THE CENTER, AND ON THE ENDS. INSTALL
THE SWING BEAM MOUNT SO THAT THE COUNTERBORED HOLES ON EACH END OF THE BEAM FACE OUT, AND THE
COUNTERBORED HOLES AT THE CENTER FACE DOWN.
2: FASTEN THE SWING BEAM MOUNT TO THE CORNER POSTS USING 6
1
2
" CARRIAGE BOLTS WITH TORQUE WASHERS.
PLACE THE CARRIAGE BOLT INTO THE TORQUE WASHER, THEN INTO THE HOLE OF THE CORNER POST AND SET WITH
A HAMMER. USE
3
8
" LOCK NUTS AND WASHERS TO SECURE THE SWING BEAM MOUNT FROM THE OUTSIDE. PLACE
BOLT CAPS OVER THE EXPOSED THREADS AFTER SECURING.
3: THE 4 X 4 X 81" TRAPEZE ARM WILL ATTACH TO THE UNIT IN THE SAME MANNER AS THE SWING BEAM MOUNT. THE
TRAPEZE ARM WILL MOUNT ON THE OPPOSITE SIDE OF THE UNIT ABOVE THE ROCK WALL.
" WASHER
BOLT CAP
8
8
" LOCK NUT
3
3
6-1/2" CARRIAGE BOLT
AND TORQUE WASHER
THE HOLE ABOVE THE SWING BEAM
MOUNT IS TO BE USED ON UNEVEN
(UPHILL) GROUND. IF INSTALLING
ON A RELATIVELY LEVEL SURFACE,
THIS HOLE WILL NOT BE USED.
4 X 4 X 81" TRAPEZE ARM
44