User Manual

29
ATTENTION: The information provided is ONLY a guide. To insure proper lug nut, lug bolt or wheel lock selection,
refer to your current lug nut to determine correct lug nut style and thread size for your vehicle.
TORQUE GUIDELINES
A calibrated torque device must be used to achieve proper torque
specifications.
Use Original Equipment Manufacturer’s torque specification. If it is not
specified in the vehicle owner’s manual contact the vehicle manufacturer.
If the Original Manufacturer does not provide a specification, check with the
aftermarket wheel manufacturer for a specification.
In the event that neither the vehicle manufacturer nor the aftermarket wheel
manufacturer give you the specification, the following MAY serve as a
guideline for passenger cars and light-trucks only:
Stud Diameter Torque Range (Ft/lbs)
12MM 75 - 85
14MM 85 - 95
7/16” 70 - 80
1/2” 75 - 85
9/16” 105 - 115
5/8” 125 - 135
IMPORTANT: Check new fasteners against the vehicle wrench
making sure they are same size. If the new fasteners have a different
hex size than the original equipment wrench provided with vehicle, be
sure to advise the customer that a correct size wrench will be required to
remove the new aftermarket fasteners being installed.
(more installation information on next page)
PROPER INSTALLATION TIPS
ATTENTION: The information provided is ONLY a guide. To insure proper lug nut, lug bolt or wheel lock selection,
refer to your current lug nut to determine correct lug nut style and thread size for your vehicle.