Operation Manual
129737
Instructions for Use18
Drying
Drying programme selection clements are fited in
the control panel as well as the indicator light
which is on during the operation of the machine.
Preparing the Laundry for
Drying
x Sort the laundry before drying according to type
of the laundry.
x Do the buttons, zippers, join the strings and pull
out the pockets.
x Very delicate laundry (fine underwear with
laces) should prior to drying be put in a special
sack so that it won't get damaged by buttons,
zippers and pins.
x We recommend loading the drum with items of
different size. Larger pieces of laundry get
tucked during drying. So we recommend you
take them out, shake them and then put them
back.
x When drying large sheets (bed sheets, table
cloths) put 2 to 3 pieces for one load and when
drying delicate smaller items (shirts, blouses) fill
only 5 to 6 pieces for one load (max 2,5 kg).
x Never fill the appliance with drip wet laundry.
x Most clothes nowadays have labels marked
with recommended drying mode.
DRYING
Drying in tumble drier allowed
Wring, hang on rope and dry
No wringing, drip dry
Wring, dry flat
Drying in tumble drier not allowed
Drying at normal temperature
Drying at lower temperature
ON – OFF button
The appliance is switched on and off by pushing
the ON/OFF button.
Signal lamp operation
Signal lamp is on when the appliance is in
operation.
Prior drying
x Switch the dryer on by pressing the ON/OFF
button.
x Before first selection of drying program set the
program selection knob for 1 second to the
position STOP/0.
x Set the program selection button to the desired
drying program. Signal lamp, adjacent to the
selected program is lit (except with the selected
time program).
x Press the "START" button to start the program.
The beginning of operation is signaled by a
beep. The program signal light goes off and
actual humidity level indicator light turns on.
x If you wish to change the selected drying
program after the machine had been put in
operation, set the program selection button
back to the position STOP/0 for 1 second, and
after that you may select any desired drying
program, and start it by pressing the START
button. In case this procedure is not performed,
the machine will continue executing the
originally selected program, notwithstanding the
position of the program selector.
x If the preceding program has been completed
(indicator light END and ANTI-CREASE are lit),
you may select a new program and start it with
the START button. It is not necessary to set the
program selection button to the STOP/0
position.
Drying program selection button
The appropriate program is selected by operating
the program selector switch, which may be turned
in either direction. There is a basic choice of three
drying groups:
9 12 14 13
10 11