Operation Manual

316971
* UKS: universal stability control - this function prevents excessive vibrations during spinning.
In case you were not successful in repairing the malfunctions in
spite of the above suggestion chart, call the nearest authorized
service shop.
Repairing the failure arising from inappropriate connections or
use of the appliance is not covered by the guarantee, and the
repair expenses are paid by the customer.
26
Failure Possible cause Remedy
FAILURE 6
Program temperature not
reached
(F6 is displayed)
• Heater failure
• Inlet water too cold
• Manual addition of water
• Turn off the appliance and wait for
a few seconds;
• turn the appliance back on and
repeat the washing program.
If the failure is reported again, call a
service technician.
FAILURE 7
Water is poorly pumped
out or not at all
(F7 is displayed)
Water outlet is clogged Check if:
• the fi lter is clean,
• outlet pipe is not jammed,
• the drain is clogged,
• outlet pipe is positioned higher
than 1m.
Push START again
FAILURE 9
Water is inside the
appliance.
(F9 is displayed)
• water fl owing inside the
appliance
• supply pipe failure
• tub is leaking
Close the tap / faucet.
FAILURE 10
Required water level not
reached
(F10 is displayed)
Water level sensor not
connected to electronic circuit
• Switch off the appliance, wait a
few seconds;
• Switch on the appliance and
repeat the washing program.
If the fault reoccurs, call a service
technician.
FAILURE 11
Water supply cannot be
stopped.
(F11 is displayed)
Failure of the water supply
valve.
• Close the tap / faucet.
• Let the machine complete the
program.
If the fault reoccurs, call a service
technician.