Operation Manual

316971
• By the user
Selecting the PUMP STOP function
If you have chosen the pump stop
function, the program will
stop at the last rinse and the PUMP STOP symbol
will fl ash
on the display (washing machine door locked the entire time).
Before pressing the START (F) key, spinning rpm can be
decreased. If you do not wish to do so, the program can be
ended by pressing the START (F) key, and the washing process
will end with the spinning cycle defi ned by the program.
While washing program is running (after pressing the START
key), you can use (B) key
to decrease the spinning speed.
Manual (physical) termination
The program can be cancelled / terminated by rotating the
program selector dial (A) to the “0” position. If there is water in
the machine, select the additional program (pump + spin
).
PAUSE key
The program can be paused at any time by pressing the PAUSE
(F) key. If there is no water in the drum, the water can be opened
after a while; if there is water in the drum, the door cannot be
opened. To resume the program, press the START (F) key.
• Faults and errors
The program is interrupted in case of faults and errors.
An audio signal will notify you of such occurrence and the
type of fault will be indicated on the display (see section
Troubleshooting).
• Power failure
At electric cutout the program is interrupted, however, after the
power supply has been re-established, the program operation
automatically proceeds.
If a power failure occurs when the drum is still full of
water, be careful not to open the door before you pump
the water out.
InterruptionsInterruptions
17