Operation Manual

311220
Washing machine automatically controls the operation of individual functions during the washing
program. If any faults are identifi ed, this is reported by displaying (Fx) and the time remaining until
program completion on the display. The machine will signal the fault until it is turned off. If the fault
is on the heating system, the machine will complete the washing program, but without heating the
water.
Failures:
F2 - Door not properly closed
F3 - Water supply impeded
F7 - Water discharge impeded
In these cases, you will be able to remedy the failure by yourself (See Troubleshooting table).
F1 - Temperature sensor error
F4 - Spinning (rpm) sensor error
F5 - Motor error
F6 - Heating error
Should any of these failures occur, make note of the failure code, turn off the appliance and repeat
the program. If the failure persists, contact the nearest authorized service centre.
Various interferences from the environment (e.g. electric devices) may also cause the machine to
signal faults. In such case:
- turn off the appliance and wait a few seconds;
- turn on the appliance and repeat the washing program.
If the fault reoccurs, call the service center.
The warranty does not cover faults caused by interference from the environment (lightning strike,
electric circuit, natural disasters, etc.).
23
Troubleshooting