Operation Manual

300095

Extra rinse/ Clean water sensor

This function is for persons, especially sensitive to detergents.

Using the SELECTION knob (C) you may select one or two extra

rinses, or activate the Clean water sensor (S) - certain models

only. By activating extra rinse the display indicates adequately

increased quantity of water. If the clean water sensor is activated,

the display indicates the symbol “S” instead of water quantity. In

such cases the machine will select appropriate number of rinses

in relation to how clean is rinsing water, detected (measured) by

the sensor.

Higher water level (Water plus)

For washing heavily stained laundry.

Using the SELECTION knob (C) you may increase quantity of

water for rinsing one or two times more; for certain programs

this function is available also for washing. Appropriately larger

quantity of water is indicated by the display.

Cold wash

For washing less soiled or colour-sensitive clothes.

Upon switching this function ON, the heating function of this

cycle is switched OFF, therefore the whole program is adequately

shortened.

Pre-wash

Used for washing heavily stained laundry, especially with

superﬁ cial stains. In default setting the pre-wash function is off. It

is activated by pressing the SELECTION knob (C) on programs

for cotton, synthetics, delicate and mixed laundry.

Soaking

This program is intended for removal of stubborn stains. In

default setting the soaking function is off. It is engaged by

pressing the SELECTION knob (C). Soaking time may be set

from 1 h to maximum 6 hours, in 30 minute steps. At the end of

the preset time the machine automatically starts the selected

washing program.

Delayed start

The function enables delay of starting the washing procedure for

up to 20 hours, in 30 minute intervals for the ﬁ rst two hour delay,

and in hourly intervals for the rest.

Delay is set by pressing or keeping pressed the SELECTION

knob (C) for the required time of delay.