Operation Manual

240203

Program is activated by pushing the START/PAUSE button (F).

Sound signal conﬁ rms the start, the display indicates ﬁ rst

washing stage and time left to the end of washing. Washing

stages are consecutively displayed in accordance with the

selected program.

If the machine is set with the delayed start, it will start operating

after the delay time expires.

If the pump stop function was set, the program will stop at the

ﬁ nal rinse and the display indicates ﬂ ashing sign pump stop

(RINSE).

You may conclude the program by pressing the START knob (F)

and the machine will ﬁ nish the program with the spin, determined

by that particular program.

In case you would like to alter the washing program, turn the

program selector to the position “0”, followed by the selection of

rinse or merely pumping the water out.

If no program is selected and started and no other action is taken

within ﬁ ve minutes after turning on the machine, the display

illumination will be automatically turned off to save energy.

Display illumination will turn on again when you rotate the

program selector dial or press any button.

If no action is taken after the end of the program (e.g. if the door

is not opened, etc.), display illumination will also turn off after ﬁ ve

minutes.

LOW POWER MODE

P o = weighted power in ‘off mode’ [W] 0,06

P l = weighted power in the ‘left on mode’ [W] 1,46

T l = time in ‘left on mode’ [min] 10,0

Low water temperature, low network voltage, and

smaller loads of laundry may extend the washing time;

the time indicated on the display is constantly adjusted

to account for such conditions.

- End of operation

• Sound signal indicates that you may now open the door of the

machine.

• Extract the laundry from the drum and remove any alien

objects from the door gasket.

• Leave the door ajar to allow the interior to dry.

• Close the water inlet faucet.

• Switch the machine off by turning the program selector (A) to

position “0”.

• Pull the power lead from the socket and cut the power supply

from the mains.

Start the operation