Operation Manual

141373

• Insert the ﬁ lter back as shown on the picture (arrow and

pointer), and tighten by turning it in clockwise direction. To

ensure good sealing the gasket surface (A) must be dirt free.

The washing machine automatically monitors the execution of particular functions during the

operation, and reports any detected failures. In such cases both signal LED’s start ﬂ ashing in

certain sequence, accompanied by the audible signal, sounding in the same sequence as the

indicator LED’s ﬂ ash. The ﬂ ashing sequence changes in accordance with the nature of the

detected failure.

In some cases you may attempt removing certain failures yourself, so count the number of ﬂ ashes,

repeating after certain pauses.

The machine signals failures immediately after detecting them and stops the program, except for

heater failure, where the machine completes the washing program without heating water.

Failures

In certain cases you may remove the failure yourself:

2 - two ﬂ ashes: door is not correctly closed

3 - three ﬂ ashes: inappropriate water intake

7 - seven ﬂ ashes: inappropriate water outlet.

In all other instances mark the number of ﬂ ashes indicating the failure, switch off the machine and

call nearest authorized service center (LED’s continue ﬂ ashing until you switch the machine off).

Interferences from the ambient (for example electrical wiring) could induce signalization of different

faults. In such cases:

- switch the appliance off, and wait for a few seconds;

- switch the appliance back on and repeat the washing program.

If the fault repeats, call authorized service shop.

Warranty shall not apply in case of failures due to interferences from the environment (lightning

stroke, power supply circuit faults, natural disasters).

Failures