Operation Manual

239828

Washing machine controls the operation of particular functions during washing. If irregularities

are detected, the fault is signaled by displaying a message (Fx) on the display, and by rhythmical

ﬂ ashing of the LEDs. Simultaneously with the ﬂ ashing of the LEDs, a sound signal is emitted

several times, in the same rhythm. The machine signals the fault as soon as it is detected, and

the program progress is paused. If the fault is in the heating system, the machine completes the

washing program, but without the heating function.

If the fault is signaled during washing machine operation, the error code and remaining washing

time are indicated alternately on the display.

The fault is indicated until the washing machine is turned off.

Failures:

2 - Two ﬂ ashes: door is not correctly closed

3 - Three ﬂ ashes: inappropriate water intake

7 - Seven ﬂ ashes: inappropriate water outlet.

In these cases, you will be able to remedy the failure by yourself (See Troubleshooting table).

1 - One ﬂ ash: temperature sensor failure

4 - Four ﬂ ashes: spinning sensor failure

5 - Five ﬂ ashes: motor failure

6 - Six ﬂ ashes: Heater failure

Should any of these failures occur, make note of the failure code, turn off the appliance and repeat

the program. If the failure persists, contact the nearest authorized service centre (the LEDs will

continue to ﬂ ash until the appliance is turned off).

Various interferences from the environment (e.g. electric devices) may also cause the machine to

signal faults. In such case:

- turn off the appliance and wait a few seconds;

- turn on the appliance and repeat the washing program.

If the fault reoccurs, call the service center.

The warranty does not cover faults caused by interference from the environment (lightning strike,

electric circuit, natural disasters, etc.).

Troubleshooting