Operation Manual

240156

• Setting the sound signal

The appliance has the possibility of setting stronger sound

signal. Press the Reduced spin RPM knob

(B) (or Spin

off knob

) and switch the machine on. The selection of the

function is conﬁ rmed by the sound signal. The function is

disengaged following the same procedure.

LOW POWER MODE

P o = weighted power in ‘off mode’ [W] 0,07

P l = weighted power in the ‘left on mode’ [W] 1,50

T l = time in ‘left on mode’ [min] 10,0

• Before washing sort out the laundry according to the type, degree of dirtiness and color

resistance.

• Prior selecting the washing program consult the sewn tab with information on a particular piece

of laundry (see Maintenance Chart on the last page).

• Wash separately the new colored textile products for the ﬁ rst time.

• Wash heavily soiled laundry in small quantities and add more detergent.

• Treat stubborn stains with special stain remover, it will save energy.

• With lightly stained laundry select washing program without pre-wash, use short program and

select lower washing temperature. This way you may save up to 50% of energy.

• Avoid washing too little quantities of laundry because of energy saving and for better

performances of the appliance.

• The largest allowed quantity of dry laundry is indicated in the Program chart.

• Before washing empty the pockets, close zip fasteners, and remove any metal fasteners or

badges that might clog the drain or damage the laundry or drum interior.

• Loosen the stacked laundry prior inserting it into the drum.

• Use only detergents for machine wash.

• Add powder or liquid detergents according to the manufacturer’s instructions.

• For different washing temperatures and selected washing programs, please note the

recommendations provided by detergent manufacturers.

• If water hardness level exceeds 14°dH degrees, the use of water conditioner is required. Any

damage to the heater due to failure to use a water conditioning agent shall not be covered by

this warranty.

• Chlorine-based whitening agents are not recommended, as it can damage the heater.

Tips for washing and energy saving