Operation Manual

240156
Select the particular function after the selection of the
basic program, but prior pressing the START button (F).
Pump stop
• This function is switched on after the selection of a basic
program by pressing the knob (E). It may also be switched on
during the operation, prior last rinse. Indicator LED above the
washing cycle symbol is lit.
• The program stops at the end of last rinse, prior spinning:
laundry remains soaked in water and prevents crease, if you
are unable to remove it from the drum immediately after the end
of washing cycle.
• Indicator LED above the knob is fl ashing.
• The selected program is completed by pushing the START
button (F), but you may also apply partial programs (pumping
or spinning), but you must fi rst return the program selector (A)
to the “0” position for at least one second, prior selecting any of
the partial programs.
• When program continues, indicator LED above the knob goes
off.
Higher water level (Water plus)
• For better rinse, which is important for extra sensitive skin to
detergents.
• For washing heavily stained laundry.
Half-program
• Used for washing smaller quantities of laundry.
• Reduced consumption of detergents and water, and shortens
washing time.
•
When the program Cotton 30°C is active press the Half Load
key
to activate the program Cotton 30°C - Quick 17´ .
Quick program
• Convenient for washing less stained laundry.
• Washing time is reduced (see Program chart).
• By pressing the key quick program
on the program Cotton
30°C, activate the program Cotton 30°C-quick
.
Reduced spin RPM
• Reduction of spin RPM depends on program selection and
maximum RPM for particular type of machine.
12