Operation Manual

278988

• Before washing sort out the laundry according to the type, degree of dirtiness and color

resistance.

• Prior selecting the washing program consult the sewn tab with information on a particular piece

of laundry (see Maintenance Chart on the last page).

• Wash separately the new colored textile products for the ﬁ rst time.

• Wash heavily soiled laundry in small quantities and add more detergent.

• Treat stubborn stains with special stain remover, it will save energy.

• With lightly stained laundry select washing program without pre-wash, use short program and

select lower washing temperature. This way you may save up to 50% of energy.

• Avoid washing too little quantities of laundry because of energy saving and for better

performances of the appliance.

• The largest allowed quantity of dry laundry is indicated in the Program chart.

• Before washing empty the pockets, close zip fasteners, and remove any metal fasteners or

badges that might clog the drain or damage the laundry or drum interior.

• Loosen the stacked laundry prior inserting it into the drum.

• Use only detergents for machine wash.

• Add powder or liquid detergents according to the manufacturer’s instructions.

• For different washing temperatures and selected washing programs, please note the

recommendations provided by detergent manufacturers.

• If water hardness in your pipeline exceeds 14°dH, we recommend using water softeners. Any

damage to the heater due to failure to use a water conditioning agent shall not be covered by

this warranty.

• Chlorine-based whitening agents are not recommended, as it can damage the heater.

• Failures

Program is suspended in case a failure occurs. These are

indicated by the ﬂ ashing LEDs (see cf. Failures).

• Power failure

At electric cutout the program is interrupted, however, after the

power supply has been re-established, the program operation

automatically proceeds.

If a power failure occurs when the drum is still full of

water, be careful not to open the door before you pump

the water out.

LOW POWER MODE

P o = weighted power in ‘off mode’ [W] 0,07

P l = weighted power in the ‘left on mode’ [W] 1,80

T l = time in ‘left on mode’ [min] 10,0

Tips for washing and energy saving