Operation Manual

278988
• Push the START button (E). The machine starts operating after
a few seconds. LED indicating the current washing stage lights
up. If the door is not closed after the machine is switched on,
the START LED starts fl ashing again after a few seconds.
When you close the door, the machine initiates the selected
program.
• As each washing stage is completed the relevant washing stage
indicator LED goes off and the subsequent one goes on.
• In case you would like to alter the washing program after the
initiated washing operation, turn the program selector for one
second to the position “0”, followed by the selection of a new
program. Switching the machine off deletes any previously
selected additional functions(i.e. Pump stop), so they have to be
reactivated.
Upon switching OFF, all additional pre-selected
functions are deleted; therefore they must be switched-
ON again.
- End of operation
Flashing LED’s for particular washing stages indicate that the
program was completed.
• Washing machine door can be opened.
• Extract the laundry from the drum and remove any alien objects
from the door gasket.
• Leave the door ajar to allow the interior to dry.
• Close the water inlet faucet.
• Switch the machine off by turning the program selector to
position “0”.
• Pull the power lead from th
e socket and cut the power supply
from the mains.
• By the user
Own interruption
You may stop the program by turning the program selector (A)
to the position “0”. If there is water in the drum select one of
additional programs (pumping
, spinning ) to empty the
water and terminate the program.
PAUSE knob
By pressing the PAUSE knob (E) program may be suspended
at any time. After certain time you may open the door if there is
no water in the drum, otherwise this is not possible. Program is
continued by pressing the START knob (E).
Start the operation
Interruptions
13