Operation Manual

141344
• Open the door of the machine
• Load the laundry into the drum
• Close the door
• Open the water inlet faucet
• Push the ON/OFF button and select the program
• Add washing and treatment agents (detergent and softener)
• Start the operation by pushing the START knob (C)
- Open the door of the machine.
Door is opened by pulling the handle (lever) on the right hand
side of the door towards you.
- Sort the laundry by the type of fabrics.
Do the buttons and zippers, tie the strings and pull out
the pockets.
Very delicate laundry should be put in a special
protective sack.
It is suggested to load the drum with items of different
sizes.
Pay attention to the labels on the clothes, indicating
the recommending washing mode (see table of
textile treatment symbols on the last page of these
instructions).
- Load the laundry into the drum.
Check that the drum is empty.
- Close the door of the appliance.
- Open the water inlet faucet.
- Push the ON/OFF button and select washing program.
Program is selected by turning the program selector (A) from the
“0” position to the desired washing program. The ON/OFF signal
LED starts fl ashing. The program selector (A) may be turned in
both directions, and the appropriate program selected according
to the type of laundry washed and the required washing
temperature (see Program Chart for help). You may select basic
or partial programs.
Selected program may be changed at random prior pushing the
START button (C).
- Selection of basic programs (
, , , )
Basic programs represent integral programs containing all
washing stages, including softening and spinning (see Program
Chart). They are selected by turning the program selector to the
appropriate position.
Cotton: whites/colored
Normally stained cotton and fl ax bed linen and underwear, table
Washing procedureWashing procedure
Washing machine
operation
Washing machine
operation
9