Operation Manual

231711

• Before cleaning, drain any water from the machine via drain

pipe (certain models only).

• Turn it anti-clockwise, pull it out and clean under running

water.

• Insert the ﬁ lter back as shown on the picture, and tighten by

turning it in clockwise direction. To ensure good sealing the

gasket surface (A) must be dirt free.

The washing machine automatically monitors the execution of particular functions during the

operation, and reports any detected failures. In such cases both signal LED’s start ﬂ ashing in

certain sequence. Flashing sequence changes in accordance with the nature of the detected

failure.

In some cases you may attempt removing certain failures yourself, so count the number of ﬂ ashes,

repeating after certain pauses.

The machine signals failures immediately after detecting them and stops the program, except for

heater failure, where the machine completes the washing program without heating water.

Failures:

2 - Two ﬂ ashes: door is not correctly closed

3 - Three ﬂ ashes: inappropriate water intake

7 - Seven ﬂ ashes: inappropriate water outlet.

In these cases, you will be able to remedy the failure by yourself (See Troubleshooting table).

1 - One ﬂ ash: temperature sensor failure

4 - Four ﬂ ashes: spinning sensor failure

5 - Five ﬂ ashes: motor failure

Failures