Use Instructions
Table Of Contents
- Front page
- Contents
- Safety instructions
- Installation and connection
- Before using the appliance for the first time
- Storing wine
- Operation
- Solving problems
- Environmental aspects
- Service and warranty
Error notifications
If a component inside the appliance is failing, a notification will pop-up.
The notification will display a code. Codes for these errors can be found in the table below.
Code shown on
Display 'H'
Code shown on
Display 'T'
Description
Error
Code
E0E0
Communication error from power board to user
interface electronics.
E0
1EWi-Fi module can not turn on.E1
4EWi-Fi module can not connect to Cloud Service.E4
5E'Hard Pairing' process not successful.E5
6E'Unpair all' process not successful.E6
E8E8
Communication error from user interface electronics
to power board.
E8
9EDoor sensor error.E9
1FAppliance's compartment fan error.F1
2FCondenser fan error.F2
1HAppliance's compartment humidity sensor error.H1
1PProximity sensor error.P1
1tEnvironment temperature/humidity sensor error.t1
2tAppliance's compartment temperature sensor error.t2
3tEvaporator temperature sensor error.t3
1UVibration sensor error.U1
18Wi-fi modul error.81
In case there is a communication error between power board and user interface electronics, other
errors will not be displayed.
If any error indication on displays 'T' and 'H' is active, then other action on display is not possible.
For that there are, anyway, some exceptions:
• in case of any of alarms is active: alarm key is active (to reset active alarm),
• in case of active Key Lock mode: key lock key is active (for deactivating key lock),
• On/Off key is active, to enter Off mode with a 3 seconds press.
If several different errors are active in the same time, they will be displayed sequentially.
If after 3 hours since the user closed the message, the error is still not resolved, the error message
is displayed again.
61
Solving problems