Operation Manual

260437

• The appliance should be installed in a dry and well ventilated

room. The appliance will operate correctly if the environment

temperature is within the ranges listed in the table below.

The appliance class is indicated on the label with the basic

information on the appliance.

Class Temperature

SN (subnormal) from +10°C to +32°C

N (normal) from +16°C to +32°C

ST (subtropical) from +16°C to +38°C

T (tropical) from +16°C to +43°C

Appliance installation should be carried out by at least two

persons to avoid any physical injury or damage to the appliance.

• The appliance should stand ﬁ rmly in an upright position on a

sufﬁ ciently solid base. At the front, the appliance is ﬁ tted with

two adjustable legs that can be used to level the appliance

(only with some models). Rear side of the appliance is ﬁ tted

with wheels (certain models only) facilitating the positioning of

the appliance at the preselected place.

• If there is a kitchen furniture element above the appliance,

there should be a clearance of at least 5 centimeters between

this element and the refrigerator, to ensure sufﬁ cient cooling of

the condenser unit.

• Two spacers attached to the appliance must be ﬁ tted onto the

upper edge of the condenser, thus preventing the appliance

from being installed too close to the wall (only some models

have it). Spacers are manufactured for all-purpose function

depending on the distance of the condenser from the

appliance. Therefore turn spacers correspondingly and ﬁ x

them to the appliance.

• Do not expose the appliance to direct sunlight and do not

place it near sources of heat. If this cannot be avoided, install

an insulation panel.

Selecting the room

Installing the appliance

Installation and connection