Operation Manual

Fault: Cause/Remedy

Bulb replacement:

• Before replacing the light bulb, disconnect the appliance

form the power supply. Using the screwdriver remove the

cover, replace the bulb with a new one (E14, same voltage

as the factory one) and ﬁ t back the cover.

• Don’t forget: the old bulb does not belong to organic waste.

• Light bulb is consumption material and is not covered by the

warranty.

Water dispenser doesn’t work after

connecting the appliance to the

mains power

• Check pipe couplings.

• Check water level in the bottle. Before ﬁ rst use, and if the

dispenser was out of use for a longer period of time, the

water bottle must be full, meaning that the lowest water

level must be 5 cm below the pump.

Error code displayed: • If the character E1 appears on the digital display call service

assistance.

Troubleshooting helpful hints: • If you are not able to ﬁ x the trouble by any of the above tips,

disconnect the power cord from the mains outlet, wait 10

minutes, and reconnect the appliance.

In case trouble persists, contact the nearest authorized

service center, giving them the type, model and serial

number of the appliance, written on the rating plate in the

inside of the appliance.

142519