Installation Instructions

Instruction for Changing Direction of opening the door8
For two - door appliances, 500 mm width
If you find the direction of opening the door on your
appliance inconvenient, you can change it. Holes
on the opposite side have already been prepared
in the factory and are now plugged.
• Remove the cover on the upper hinge,
unscrew the hinge and take off the freezer
door (the door is not fixed on the middle
hinge), don't forget to remove the washer
from the middle hinge.
• Unscrew the lower hinge with foot and
washer and remove the refrigerator door.
• Unscrew the middle hinge and the other foot.
• Fix the lower hinge with foot (and washer) to
the opposite side and fix the other foot on
the place where previously was the hinge.
• Put the refrigerator door on the lower hinge.
• Rotate the middle hinge for 180°, replace it
to the opposite side of the door and fix it.
• Put on the washer first and then the upper
door.
• Fix the upper hinge and cover it.
• Unscrew the handles and replace them to
the opposite side (not for handles mouinted
horizontally). Some screws are covered with
caps. Take them off before undoing the
screws.
• Plug the remaining holes with decorative
caps.
• Check the gasket, it shouldn't be creased
and it should seal well. In case it does not fit
perfectly, pull it out and rotate for 180°. In
certain models it is not possible to replace
the door gasket. Should the seal not adhere
to the casing of the appliance perfectly, it will
have to be heated from a suitable distance
(by means of hair drier, for example) and
lightly stretched to the required height. In
certain models it is not possible to replace
the door gasket.
1 Cover for the upper hinge
2 Upper hinge
3 Middle hinge
4 Middle hinge washer
5 Lower hinge with foot
6 Lower hinge washer
7 Foot
8 Handle