Operation Manual

Instructions for Use 21
• Place the upper door of the appliance on
the fastener (functioning as upper hinge).
• Rotate the middle hinge 180°, replace it
on the other side and fix it.
• Put the lower door on the middle hinge,
insert the fastener into the corner element
with a hole and fix the lower hinge with
washer.
• Unscrew the handles and replace them to
the opposite side (not for handles
mouinted horizontally).
• Some screws are covered with caps.
Take them off before undoing the screws.
• Plug the remaining holes with decorative
caps.
• Check the gasket, it shouldn't be creased
and it should seal well.
Should the seal not adhere to the casing
of the appliance perfectly, it will have to
be heated from a suitable distance (by
means of hair drier, for example) and
lightly stretched to the required height.
6
6
1 Lower hinge with foot
2 Foot
3 Middle hinge
4 Washer
5 Fastener
6 Handle
Maintenance and Cleaning
Automatic Defrosting of the
Refrigerator
There is no need to defrost the refrigerator,
because ice depositing on the inner back wall is
defrosted automatically.
Ice is depositing on the inner back wall during
the compressor operation; later on, when the
compressor is not operating ice is defrosting
and water drops collect and drain through the
outlet in the inner back wall into the drain pan
situated above the compressor, from where it
evaporates.
Manual Defrosting of the Freezer
When the frost and ice layer in the freezer is 3-
5 mm thick, you should clean the freezer.
• Few hours before defrosting set the
thermostat to position 7, so that packages
are well frozen. Reset the thermostat to
STOP (0) position and disconnect the power
supply. Empty the freezer and take care that
the packages remain frozen.
• Leave the door open for a while so that you
can easy scrape off the frost. Use the plastic
scraper but be careful not to damage the
inner surfaces of the freezer.
• Wipe up the scraped frost and ice before it is
completely defrosted.
• Avoid using defrosting sprays, as they may
cause damage to the plastic parts and may
be hazardous to health.
Cleaning the Appliance
Disconnect the power supply before
cleaning the appliance.
Do not use coarse or aggressive cleaning
agents as you can damage the surface.