Operation Manual

142444

Fault: Cause/Remedy

Difﬁ cult door opening:

• If you want to open the immediately closed door, you

may experience trouble in doing so. This happens

because certain quantity of cold air escapes from the

appliance through the open door and is replaced by

warm ambient air. Cooling of such air creates negative

pressure (vacuum) and suction, which prevents easy

opening of the door. Situation is normalized after a few

minutes, and you can open the door with ease.

Bulb replacement:

• Before replacing the light bulb, disconnect the

appliance form the power supply. Using the

screwdriver remove the cover, replace the bulb with a

new one (E14, same voltage as the factory one) and

ﬁ t back the cover.

• Don’t forget: the old bulb does not belong to organic

waste.

• Light bulb is consumption material and is not covered

by the warranty.

Error code displayed: • If the character E1 appears on the digital display call

service assistance.

Water dispenser doesn’t

work after connecting the

appliance to the mains power

• Check pipe couplings.

• Check water level in the bottle. Before ﬁ rst use, and

if the dispenser was out of use for a longer period of

time, the water bottle must be full, meaning that the

lowest water level must be 5 cm below the pump.

Troubleshooting helpful hints: • If you are not able to ﬁ x the trouble by any of the

above tips, disconnect the power cord from the mains

outlet, wait 10 minutes, and reconnect the appliance.

In case trouble persists, contact the nearest

authorized service center, giving them the type, model

and serial number of the appliance, written on the

rating plate in the inside of the appliance.