Operation Manual

142420

The appliance needs no special defrosting procedure, because

ice deposited at the inner back wall is defrosted automatically.

Ice deposited on the inner back wall during the compressor

operation is defrosted when the compressor stops operating,

and condensed water drops are drained through the outlet in the

inner back wall into the drain pan situated above the compressor

where it evaporates.

For appliances without the ZeroZone drawer:

In case of excessive ice deposits at the inner rear wall of the

refrigerator (3-5 mm), switch the appliance off by pressing the

ON/OFF button and defrost it manually.

Automatic defrosting

Prior any cleaning attempt disconnect the appliance from

the mains (pull the power cord from the mains wall outlet).

Special antibacterial protection in top layer of inner walls

prevents multiplication of bacteria and maintains the interior

clean and germ free. Make sure to remove traces of any

cleansing agents you had been using.

• Clean the exterior of the appliance with water and liquid

detergent.

• Do not use abrasive or aggressive agents (such as stainless

steel cleansers) for cleaning of plastic and coated surfaces as

you can damage them.

• Clean coated surfaces with soft cloth and alcohol based

cleansing agent (for example glass cleaners).

• Wash the interior of the appliance with liquid detergent and

lukewarm water, mixed with a little vinegar.

- For appliances without the ZeroZone drawer:

Groove and drain outlet located below the cooling panel at

the rear wall collect the drained water, so they must not be

clogged (with food particles, for example). Make sure you

inspect them periodically and clean if necessary (use plastic

straw to free the outlet hole).

• The condenser on the rear wall must always be clean and

free of dust or kitchen fumes deposits, therefore clean the dust

periodically with non-metallic brush or vacuum cleaner.

• Clean also the drip pan above the compressor. If you

removed the pan, please make sure you replace it to the same

position, and check that it is in completely horizontal position!

• Ice and/or frost deposits exceeding 3-5 mm increase energy

consumption, so you need to remove them regularly. Do not

use sharp pointed objects, solvents or sprays.

• After cleaning switch the appliance on and reload the food.

Defrosting the appliance

Cleaning