Operation Manual

142396

Required tools; socket spanner nr. 8, screwdriver, torx 25

Caution! After unscrewing of before ﬁ xing hinges, hold the door

to prevent it from falling and damaging.

1. Remove upper hinge cover (keep it for eventual later use),

together with cover on the opposite side of the upper hinge

cover (on the opposite side you will insert the attached cover

during the assembly), and remove the cover on the opposite

side of the upper part of the door.

2. Unscrew upper hinge screws and remove the door from the

bottom hinge.

3. On the bottom side of the door unscrew the swing stopper

screws and remove the stopper (A) keep this stopper for later

use. Fix the attached stopper with its bearing on the opposite

side of the door.

4. Unscrew the forced door closure system (B) and ﬁ x it to the

opposite side of the door (certain models only).

5. Remove handle screw covers, unscrew handle screws, and

remove plastic pegs on the opposite side.

6. Tilt the appliance backward (max. 35°) to lean to the rear

side of the cabinet. Unscrew the leg support screws (C) - left

and right, and remove the leg support cover (D). Unscrew

and remove, then reciprocally replace the position of end

switch (E) and decorative peg (F) (for models with forced door

closing system). Place this on opposite side. Unscrew three

screws ﬁ xing the bottom hinge (keep the hinge for later use),

and ﬁ x the attached bottom hinge on the opposite side.

7. Proceed with the assembly procedure in opposite sequence.

Reverse door swing