Operation Manual

142396

Fault: Cause/Remedy

The appliance does not operate

after connection to the mains:

• Check if there is power in the socket and if the appliance is

switched on.

Cooling system operates

continuously without intermittent

stoppages:

• Ambient temperature too high.

• Frequent opening of the door, (open too long).

• Door not closed properly (particle between door gasket,

sagged door, check gasket sealing, etc...).

• Excessive quantity of fresh food inserted at once.

• Refrigerator sensor (A) is crammed with fresh food. Free

the sensor and allow air to circulate around it.

• Check air circulation for sufﬁ cient cooling of the

compressor, and clean the condenser.

Excessive ice formation at the rear

interior wall of the refrigerator:

• Frequent opening of the door, door open too long.

• Placing hot food in the refrigerator.

• Food is touching the rear interior panel.

• Bad door sealing; clean or replace the gasket if dirty or

damaged.

Water dripping from the appliance: • Drain outlet is clogged, drain water drips past the

collection groove.

• Clean the clogged outlet using plastic straw.

• Please thaw out larger ice deposits manually (see chapter

Defrosting).

Bulb replacement:

• Before replacing the light bulb, disconnect the appliance

form the power supply. Using the screwdriver remove the

cover, replace the bulb with a new one (E 14, max. same

voltage as the factory one) and ﬁ t back the cover.

• Please dispose of this correctly.

• Light bulb is consumption material and is not covered by

the warranty!

• Bulb lamps used in this appliance are special purpose

lamps selected for household appliances use only. They

are not suitable for household room illumination.

Troubleshooting guide