Operation Manual

Instructions for Use22

Disposing of the Worn Out Appliance

• When your appliance finally wears out, dispose it of. If the appliance

has a lock, break it, in order to prevent eventual accidents (danger of

children get locked inside the appliance).

• The refrigerating system of the appliance is filled with refrigerant and

insulating substances which should be separately treated and

processed. Call your nearest authorised service agent or specialised

servicing centre. If you don't find one, contact your local authorities or

your distributor. Be careful not to damage the tubes on the rear wall

of the appliance (danger of pollution).

Placing and Installation

Choosing the Right Place

Place the appliance in a dry and regularly ventilated room. Allowed

ambient temperature depends on the model (class) of the appliance

and is stated on the rating plate of the appliance.

Class Ambient temparature

SN (sub-normal) from + 10°C to + 32°C

N (normal) from + 16°C to + 32°C

ST (sub-tropical) from + 18°C to + 38°C

T (tropical) from + 18°C to + 43°C

Never place the appliance near heat emitting devices (e.g. cooker, radiator,

water heater or similar devices) and do not expose it to direct sunlight.

The appliance should be positioned at least 3 cm away from the

electric or gas cooker and at least 30 cm away from the oil or coal

stove. If this is not possible, use an appropriate insulation.

Behind the appliance there should be free space at least 200 cm

wide

and above the appliance the high kitchen units should be at least 5 cm

away from the appliance in order to assure adequate ventilation of the

condenser unit.

Placing the Appliance

• Place the appliance firmly on a solid base. Some appliances have

adjustable feet on the front side; use them to level the appliance

(Fig. 1).

• Two spacers attached to the appliance must be fitted onto the upper

edge of the condenser, thus preventing the appliance from being

installed too close to the wall. Spacers are manufactured for all-

purpose function depending on the distance of the condenser from