Operation Manual

Instructions for Use
8
After cleaning, connect the appliance to power
supply and reload it.
Switch Off the Appliance When
Not In Use
If you do not intend to use the appliance for a
longer period, set the thermostat knob to the
STOP (0) position. Disconnect the power supply,
take out the foods and defrost and clean the
appliance. Leave the door slightly open.
Trouble-Shooting Guide
During the service, you can come across some
troubles that in most cases result from improper
handling of the appliance and can easy be
eliminated.
The Appliance Fails to Operate After
Connecting to the Mains Supply
x Check the supply in the outlet socket and make
sure the appliance is switched on (thermostat
knob in operating position).
Continuous Operation of the
Cooling System
x The door was frequently opened or it was left
opened for too long.
x The door is not properly closed (the door may
sag, the gasket may be polluted or damaged).
x Perhaps you have overloaded the appliance
with fresh foods.
x The reason may be inadequate ventilation of
the compressor and condenser (assure
adequate air circulation and wipe off the
condenser).
Noise
Cooling in refrigerating-freezing appliances is
enabled by the refrigerating system with
compressor, which produces noise. How noisy
the appliance is depends on where it is placed,
how it is used and how old the appliance is.
x During the operation of the compressor the
noise of liquid is heard and when the compressor
is not operating, the refrigerant flow is heard. This
is a normal condition and it has no influence
whatsoever on the lifetime of the appliance.
x After starting the appliance, the operation of
the compressor and the refrigerant flow may be
louder, which does not mean that something is
wrong with the appliance and it has no
influence on the lifetime of the appliance.
Gradually the noise is reduced.
x Sometimes unusual and stronger noise is
heard, which is rather unusual for the
appliance. This noise is often a consequence of
inadequate placing.
The appliance shall be placed and levelled
firmly on solid base.
It should not touch the wall or kitchen units
standing next to it.
Check the accesories in the interior of the
appliance, they should be placed correctly in their
positions; also check the bottles, tins and other
vessels that might touch each other and rattle.
WE RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO
INFLUENCE ON THE OPERATION OF THE APPLIANCE.