Instruction manual

Instructions for Use
5
x For the sake of environment protection - be
careful not to damage the rear wall of the
appliance (the condenser unit or the tubes - for
example when moving the appliance) or any
part of the refrigerating system inside the
appliance. Do not use sharp object for
defrosting the appliance. Use only enclosed
tools or tools recommended by the
manufacturer.
x The refrigerating system of the appliance is
filled with refrigerant and oil, so when the
appliance is damaged, handle it with care and
dispose it of in compliance with environmental
protecting precautions.
x In the supply cord is damaged, it must be
replaced by the manufacturer or his service
agent or a qualified person in order to avoid
hazard.
x The rating plate is inside the appliance or
outside on the rear wall.
Positioning and Installation
Choosing the Right Place
Place the Pantry kitchen in a dry and regularly
Allowed ambient temperature depends on the
model (class) of the appliance and is stated on
the rating plate of the appliance.
Do not place the unit near heat-emitting devices
(e.g. cooker, radiator, water heater or similar
devices), and do not expose it to direct sunlight.
Class Ambient temperature
SN (sub-normal) od + 10°C do + 32°C
N (normal) od + 16°C do + 32°C
ST (sub-tropical) od + 16°C do + 38°C
T (tropical) od + 16°C do + 43°C
Placing
x Place the unit firmly on a solid base.
x On the front side of the appliance, there are
three adjustable feet; two of them are used for
leveling the refrigerator, while the third is used
for leveling the whole unit.
x For fire protection, this pantry kitchen complies
with the Y class, which means that other
kitchen units can be located on both sides of
the unit; one of them should be the same height
as the unit, the other can be higher.
x Warning! The appliance should not be installed
in a built-in element or cupboard.
Connection to Power Supply
Plug the cooktop and the refrigerator power lead
to the mains supply.
The power lead must be fitted with earthing pin
(safety socket).
The standard nominal voltage and frequency are
indicated at rating plate(s) of the cooktop and the
fridge.
The connection to the mains supply and earthing
have to be made according to current standards
and regulations.
The refrigerator resists temporary voltage
tolerance between -6 and +6 %. If there is no
power supply cord provided in the pantry kitchen,
a special device for separation of all poles from
the mains supply must be included when
permanently installing the appliance, with a
minimum distance of 3 mm between the contacts
in the open position.
To replace a damaged power supply cord a
special device must be used therefore a
serviceman authorised by the producer must be
called.
Connecting the Water Outlet
Mount the sink to the water outlet according to
current regulations.
Leave the work to an expert who can at the same
time check whether the sink is watertight or not.