Instruction manual

Instructions for Use
11
and any other kind of moisture may damage the
hotplates, so always wipe them dry after
cleaning.
To maintain the appearance of hotplates you
may use a few drops of sewing machine oil and
rub it in, or use the usual cleaning and
maintaining agents, available in stores. Never
apply butter, lard and the like, as you might
provoke corrosion. Cleaning agent will penetrate
quicker if the hotplate is warm.
Hotplate rims are made of stainless steel and
might assume yellow colour with time, because of
the temperature effect. This is a physical
phenomenon, and it may be partly removed with
the usual metal cleaning agents.
Aggressive cleaning accessories for dishes are
not suitable for cleaning of rims, as they might
cause scratches.
Refrigerator
Automatic Defrosting of the
Refrigerator
There is no need to defrost the refrigerator,
because ice formation on the inner back wall is
defrosted automatically. Ice is formed on the
inner back wall during the compressor operation;
later on, when the compressor is not operating
ice is defrosting and water drops collect and drain
through the outlet in the inner back wall into the
drain pan situated above the compressor, from
where it evaporates.
Manual Defrosting of the Freezing
Compartment
When the frost and ice layer in the freezing
compartment is 3-5 mm thick, you should clean
the freezer.
x Turn the thermostat knob to STOP (0) position,
and disconnect the power supply. Empty the
compartment and take care that the packages
remain frozen.
x Place a suitable vessel under the freezing
compartment to collect the defrost water. Leave
the door of the compartment open to accelerate
defrosting.
x Avoid using defrosting sprays, as they may
cause damage to the plastic parts and may be
hazardous to health.
Cleaning the Appliance
Disconnect the power supply before cleaning
the appliance!
Do not use coarse or aggressive cleaning agents
as you can damage the surface.
Be careful to remove any cleanser agent
remaining after cleaning.
x Clean the exterior with water and detergent.
Varnished surfaces are cleaned with soft cloth
and an alcohol based cleaning agent (for
example glass cleaners). You may also use
alcohol (ethanol or isoprophylic alcohol). The
application of abrasive and specially aggressive
cleaners, such as the stainless steel cleaners,
is not appropriate for the cleaning of plastic and
coated parts.
x Remove the detachable accessories in the
interior of the appliance and clean it with water
and liquid detergent. Plastic parts cannot be
washed in washing machine.
x Wash the interior of the appliance with
lukewarm water, in which you added one or two
spoonfuls of vinegar.
x Every now and then wipe the condenser on the
rear wall. Use soft non-metal brush or vacuum
cleaner.
x Do not forget to clean also the defrost water
receptacle above the refrigerator compressor
(do not remove the receptacle).
After cleaning, connect the appliance to power
supply and reload the packages.
Switch Off the Appliance When Not
In Use
If you do not intend to use the appliance for a
longer period, set the thermostat knob to the
STOP (0) position, disconnect the power supply,
take out the foods and defrost and clean the
appliance. Leave the door slightly open.
Sink
The sink is made of stainless steel and can be
cleaned with any of the special cleaning agents
for stainless steel. Always consider the
instructions given by the manufacturer of
thecleaning agent.