Operating Instructions and Installation Instructions
492203
• Cooking hobs can be installed into worktops that are 30
to 50 mm thick.
• If the board is thicker than 40 mm, its inner edge should
be trimmed, or ground (Figure A). Thus, su cient air
circulation will be provided.
• If the thickness of your counter top exceeds 30 mm,
then the opening for the hob should be made in the
middle of the oven, with su cient clearance from the
front edge of the counter top so that the induction hob
does not touch the oven shield.
• If you wish to install the induction hob into an existing
opening, make sure if this is possible given the required
installation dimensions (installation depth of 54 mm).
• Worktop must be placed absolutely horizontal.
• Suitably protect the edges of the cut aperture.
• Connect the cooking hob to the mains power supply
(see instructions for the connection of the cooking hob
to mains power supply).
• Insert the hob into the cut aperture.
Installation procedure
18
Worktop cutout
dimensions
- SIVK6