AU Operating Instructions Dishwasher GS63160AU 2 1 3 4 5 6 7 9 8 10 1 Main power switch 8 SpeedWash 2 Program selector 9 Extra dry 3 Heavy wash 10 Half load 4 Intensive wash 11 Delayed start 5 Eco wash 12 Display 6 Quick wash 13 Rinse aid indicator 7 Rinse Safety instructions ............................................ 2 Before washing for the first time ....................... 3 Loading the dishwasher .................................... 3 Using the dishwasher .......
Safety instructions General • • • • • • Read the operating instructions and keep them in a safe place! Never use the dishwasher for any purpose other than that specified in these operating instructions. Do not load the dishwasher door or dishwasher baskets with anything other than dishes. Never leave the dishwasher door open as someone may trip on it.
Before washing for the first time Loading the dishwasher Checking water hardness Economic dishwashing Contact the local water utility to check the water hardness in your area. This is important with regard to how much detergent and rinse aid to use. • • Top up with rinse aid By using rinse aid you will improve your drying result. You will also achieve a better dishwashing result with glassware and dishes. 1 Open the rinse aid compartment lid. 2 Carefully top up with rinse aid.
Using the dishwasher 2 Turn the basket catch outwards at the end of both runners. 3 Grip the upper basket with both hands, pull it out, and move the upper basket to its other position. 4 Turn the basket catch on either side in to lock the basket in place. Add detergent 1 Prewash detergent compartment 2 Main wash detergent compartment Detergent is added according to water hardness. Follow the instructions on the detergent packaging.
PROGRAMS - Choose program Press the Program selector one or more times until the desired program symbol is lit up. Heavy wash An effective program for slightly dried leftovers. (This program is not intended for burnt food, such as on oven dishes.) Intensive wash Program for very dirty dishes, such as pans, casserole dishes and oven dishes. If these dishes do not completely fill the dishwasher, you can add plates and the like. Eco wash Use when you want to save water and energy.
• • • Activate the Extra dry option. Open the door a little once the program has finished. Allow the dishes to cool before unloading the dishwasher. Once the program has finished Once the program has finished, “End” appears on the display. The dishwasher switches off automatically after the program ends. Turn off the water tap after each use. Drying For additional drying the door should be opened 35 mm upon completion of the drying cycle.
10 / 25 --- / 25 --- / 10 --- / --- Intensive wash Eco wash 2) Quick wash Rinse 2) EXTRA - Options 1 2 2 Prewashes 35 °C 55 °C 70 °C 60 °C Main wash 1 1 2 2 2 Number of rinses --- °C 25 °C 62 °C 70 °C 65 °C Final rinse 0:07 0:20 2:20 3:35 1:45 Dishwashing time (approx. hrs:min) 0.01 0.2 0.74 1.7 1.2 Energy (approx. kWh) 1) 4 10 13.9 17 16 Water cons.
Settings Open the Settings menu: 1. First, open the door. Turn off the machine. Press and hold the main power switch until the display lights up. 2. Within 10 seconds: + - press the Program selector and the option button for SpeedWash. 3. The display shows the Settings menu (current setting and its currently set value). (Exit the menu by browsing through the menu or pressing the main power switch.) Navigate the Settings menu: Press to browse between setting values.
Care and cleaning Coarse filter 3 The coarse filter traps larger food particles, which cannot get past the drainage pump. Empty the coarse filter as necessary. In order to inspect the drainage pump, remove the coloured stop on the right in the bottom drain. 4 By inserting your finger into the hole you can turn the pump blade to release anything blocking it. 5 Replace the drainage pump stop along with the fine and coarse filters. 6 Plug the machine in again.
Spray arms Holes and bearings can sometimes become blocked. Remove any debris using a pin or something similar. The spray arms also have holes on their undersides. 2 Unscrew the spray arm bearings counterclockwise to remove the spray arm from the upper basket. Door To facilitate cleaning, you can remove the spray arms. Remember to fit them firmly back into place after cleaning. Lower spray arm • Pull the lower spray arm straight up to release it.
Troubleshooting Type of fault on the display Action F10 Overfilling Clear the drainage pump. See the chapter Care and cleaning. If the problem persists, call the service department. F11 Water outlet fault See “Water remains in the dishwasher” in the table “Problem” below. If the problem persists, call the service department.
Problem Possible causes Action The dishes are not clean. The spray arms do not rotate. Remove the arms and clean them. Check that the dishes are not blocking the spray arms. Old detergent. Detergent is a perishable Avoid large packages. product. Spots on stainless steel or silver. Incorrect detergent dosage. Dose according to water hardness. Far too much or far too little detergent results in poorer dishwashing results. Dishwashing program too weak. Select a more powerful program.
Problem Possible causes Action Water remains in the dishwasher. Blocked drainage hose. Loosen the drainage hose where it connects to the sink unit's water trap. Check that no debris has fastened. Is the coneshaped part of the pipe cut to an inner diameter of at least 14 mm? Kink in drainage hose. Check that the hose is free from kinks and sharp bends. The filters are blocked. Clean the coarse and fine filters. The filter is not locked in completely.
Installation [mm] 1214 596 30 575 720 670 123-173 718 848- 898 85 600 52 Safety instructions • • • • Connections to electricity, water and drainage must be performed by a qualified professional. Always follow applicable regulations for water, drainage and electricity. Take care during installation! Wear protective gloves! There must always be two people! Before screwing the dishwasher into place, test the dishwasher by running the Rinse program.
Placing the dishwasher The dishwasher is intended for freestanding installation, but can also be installed under a worktop. Adjust the height and slide the dishwasher into place 24 mm Freestanding 1 Make sure the surface on which the dishwasher is to be installed is firm. Adjust the dishwasher's height using its four feet so that the dishwasher is level. The dishwasher may not lean more than 5 mm. 2 6 Make any final adjustments to the front feet (the dishwasher may not lean more than 5 mm).
The hose must always discharge at least 350 mm above the bottom of the machine. Ensure that the drainage hose has no kinks. NOTE! NOTE! When the drainage hose is routed to a connection nipple on the sink unit’s water trap (see Illustration 1), please note that the hose must be attached at the same height as the underside of the sink unit. Otherwise dishwater from the sink may flow back into the dishwasher. For other connection alternatives, see Illustrations 2 and 3.
Service Information for test institute Read the chapter Troubleshooting before contacting the service department. Provide the details on the compliance plate in all contact. Include the item number (1) and the serial number (2). Request test institute information via e-mail dishwashers@appliance-development.com. The request should include the details on the product’s serial number plate. Include the article number (1) and the serial number (2). 1 2 1 2 ART. NO.: SERIAL NO.: ART. NO.: SERIAL NO.
Your notes 18
Your notes 19
Technical information Information on energy labelling Energy labelling Australian standard: AS/NZS 2007 Number of place settings: 14 Dishwashing programs: Eco wash 1) , no options Program time: 2:20 hours:minutes Connection: Cold water 20 °C Test method for noise measurement: IEC 60704-2-3 1) This dishwashing program is the standard cleaning cycle used to compile the energy labelling information.
