Operation Manual

Instructions for Use, Building- in and Connecting
5
x
Be very precise when placing the burner crown
cap upon the crown. Always keep the crown
nozzles clean and free.
crown cap
burner crown
ceratin models only
thermal coupling
(certain models only)
correct position of
burner components
Ignition and operation of burners
Gas burners may be ignited with the electric
ignition device, built-in adjacent to each burner
(specific models only).
Single handed ignition
(specific models only)
To ignite the gas burner, press the selected
burner knob and turn it to the maximum power
position. The electric spark from the ignition
device flashes and sets fire to the escaping gas.
In case the electric ignition device may fail
due to power failure or moisture upon the
ignition spark, you may ignite the gas burner
with a simple match or a cigarette lighter.
Ignition of gas using both hands
(specific models only)
To ignite the gas burner, press the selected
burner knob and turn it to the maximum power
position. Now press the ignition device knob
several times. The electric spark from the ignition
device flashes and sets fire to the escaping gas.
In case the electric ignition device may fail
due to power failure or moisture upon the
ignition spark, you may ignite the gas burner
with a simple match or a cigarette lighter.
x Once the gas starts burning, keep the control
button pressed for about 10 seconds, until the
flame becomes constant.
x Release the button and set the desired power,
between the highest and the lowest position.
x Setting between the zero dot
and the
largest flame symbol is not recommended,
since the flame is not stable in that range, and
may easily get extinct.
x In case the flame goes out repeat the
procedure.
In case the burner fails to ignite
after 15 seconds, shut the gas to the burner off
and wait at least one minute before you attempt
to repeat the firing procedure.
x
If the burner flame is extinguished – for no
matter what reason – shut the gas to the burner
off and wait at least one minute before you
attempt to repeat the firing procedure.
x
Burner is switched off by turning the control
button to the right in the zero position
(black
dot).
gas faucet is closed
maximum power
minimum power
To ensure safe use of small
diameter dishes, place the
supplied extra wire grid upon
the auxiliary burner if
necessary.
Cookware
Selection of the adequate dish size ensures
optimized cooking time and consumption of gas.
Diameter of the dish is of utmost importance.
The flame reaching over the edge of the small
diameter dish may destroy the dish, while the
consumption of gas is increased.
Gas needs oxigen for burning. In case of
excessively large dish diameter the oxigen
supply is insufficient, consequently reducing the
burning capacity.
The wire grid (certain models only)
The wire grid is used for dishes with small
diameter. Place the grid over the auxiliary burner
crown.
Burner type Dish diameter
Large (3kW)
220-260 mm
Normal (1,75 kW)
180-220 mm
Auxiliary (1 kW)
120-180 mm