Operation Manual

7.5.201521211414
14
 The electric wiring should be equipped with a circuit breaker
able to isolate the appliance from the mains in all points,
with the distance between terminals of at least 3 mm in
open position. This may be done by means of fuses, safety
switches, etc.
 The connection should be selected in accordance with the
declared charge capacity of the mains and the fuse power.
 Such appliances are allowed to be mounted on one side
next to a high kitchen cabinet, the height of which may
exceed that of the appliance. On the opposite side however,
only a kitchen cabinet of equal height as the appliance is
allowed.
 Upon the completion of installation, live wires and isolated
cables must be adequately protected against accidental
touching.
ATTENTION !
Before attempting any repairs on the appliance, disconnect
the power supply. In accordance with the mains voltage the
appliance should be connected in line with the attached
diagram. The earthing wire (PE) must be connected to the
terminal marked with the earthing symbol .
The connection cable must lead through the relief safety
device, protecting it from accidental pulling out. Upon the
completion of installation switch all the hotplates on for about
3 minutes to check the proper functioning.
For connection to the mains is appliance equipped with cord
and plug with earth contact.
Connecting plug (socket) must be accessible for quick
unconnecting.
Damaged cord must be changed by the same one with
conductor ends braced with pressed terminals.
Electric connection of the
range