Operation Manual

136356
• The appliance may be installed in any worktop with a thickness
from 30 mm to 50 mm.
• In case there is a drawer in kitchen cabinet under the built-in
hob, it is necessary to install an additional horizontal barrier of
height 6 cm under the hob and above the drawer.
• Worktop must be placed absolutely horizontal.
• Suitably protect the edges of the cut aperture.
• By means of the supplied 4 screws fasten the supplied
tightening 4 brackets fasten to the front and the rear side of
the cooking hob and to the prepared aperture.
• Connect the cooking hob to the mains power supply (see
instructions for the connection of the cooking hob to mains
power supply).
• Insert the hob into the cut aperture.
• Press the hob fi rmly towards the worktop from above.
34
Dimensions of the built-
in hob opening
Installation procedure