Operation Manual

Instructions for use, mounting and connection
4
surface. During this period the regulation of the
cooktop is impossible.
ATTENTION !
Before attempting any repairs on the appliance,
disconnect the power supply. In accordance with
the mains voltage the appliance should be
connected in line with the attached diagram. The
earthing wire (PE) must be connected to the
terminal marked with the earthing symbol
.
The connection cable must lead through the relief
safety device, protecting it from accidental pulling
out.
Upon the completion of installation switch all the
hotplates on for about 3 minutes to check the
proper functioning.
Installation diagram
NOTE
In some connection boxes the connector bridges are placed between contacts 4 and 5, and in the others
they are stored at a designated place within the box. These boxes have the connection screws already in
open position so they need not be unscrewed. During the tightening procedure you will hear a faint “click”,
meaning that the tightening screw should be fastened tightly all the way
Connection may be carried out by means of:
rubber coated connection cables, model H05 RR-F 4x1,5 with yellow-green earthing cable;
PVC insulated connection cables, model H05 VV-F 4x1,5 with yellow-green earthing cable; or
any other suitable cables.
Mounting the built-in cooktop
Caution !
x To avoid any possible hazard, the appliance
may be installed by qualified personnel only.
x Panels and furniture lining of the kitchen
cabinet receiving the hob must be treated with
temperature resistant adhesives (100°C),
otherwise they might be discoloured or
deformed because of inadequate temperature
resistance.
x The cooking hob is intended for building into the
worktop above the kitchen element of 600 mm
width or more.
x After the installation of built-in hob make sure
that there is free access to the two fixing
elements in front.
x Suspended kitchen elements above the
cooktop must be installed at such distance to
provide enough room for comfortable working
process.
x The distance between the worktop and the
hood must be at least such as indicated in the
instructions for installation of the kitchen hood,
but in no case it may be less than 650 mm.
x The smallest distance between the edge of the
appliance and the adjacent high kitchen
cabinet is 40 mm.
x The use of hard wood decorative borders
around the worktop behind the appliance is
allowed, in case the minimum distance remains
as indicated on the installation illustrations.