Operation Manual

135074

Hob controls

• Each connection to the mains (power failure included)

is followed by automatic accommodation to the exterior

conditions in order to provide the most efﬁ cient sensor function

and render the best control of the hob.

• After the successful connection of the hob, the indicators show

the mark “-” for a few seconds which eventually disappear.

• The hob is ﬁ tted with electronic sensors which are activated if

you touch the marked surface with your ﬁ ngertip and keep it

for at least one second.

• Each touch of the sensors is conﬁ rmed by a beep.

• Do not place any objects upon the sensor surface during the

accommodation period, otherwise you may provoke error

mode. Keep sensor surface clean and free of dirt at all times.

When the hob is turned off all the hotplates are off and indicator

LED’s are off.

To switch the hob on, touch the ON/OFF sensor (A) for at least 1

second. The hob is activated and all power displays (D) indicate

»0« for a period of 10 seconds. .

Now you need to select the next setting within 10

seconds, otherwise the hob switches off again.

If you switched the hob on using the ON/OFF sensor (A), within

the next ten seconds you can switch on any hotplate.

• Set the heating power from 1 to 9 by touching sensors »+» (B)

or »-« (C). If you start the setting by touching the (-) sensor,

power indicator will be set to level ‘’4’’, and if you start the

setting by the (+) sensor, heating power will be set to ‘’9.’’

and automatic cooking mode will be activated (see section

‘Automatic cooking mode).

Continuous pressing of »+» (B) or »-« (C) ssensor the

power level is automatically increased or reduced.

Another procedure is to change power in steps is by

intermediate touching of relevant sensors.

You may only set one selected hotplate at a time.

LED display indicates »0« or „H“, depending on

the preceding hotplate temperature (see section

‘Remaining heat’).

You can also turn the hotplate off prior the end of

cooking and use the remaining heat, and save energy.

Switching the hob on

Turning hotplates on