Operating Instructions and Installation Instructions

243912

• Slightly lift the supports on the left and right side of the door

(marking 1 on the support) and pull them away from the glass

(marking 2 on the support) (see Figure 1).

• Hold the door glass by the lower edge, slightly lift it so that it is

no longer attached to the support, and remove it (Figure 2).

• To remove the third inside glass (only with some models), lift

and remove it. Also remove the rubbers on the glass (Figure

3).

• To replace the door, observe the reverse order.

Note: To replace the glass, make sure the markings

(crescent) on the door and the glass are aligned (Figure

4).

REMOVING AND REPLACING THE OVEN DOOR WITH A

CAM HINGE

• Completely open the oven door. Lift the clips of the lower

hinge supports on both sides to the upright position and clip

them to the plug of the upper hinge supports.

• Close the oven door half way and gently pull them out.

Replace the door in the reverse order.

• Insert the door in the half-closed position (angle of

approximately 60°) by pushing them towards the oven while

opening them all the way. Pay attention to the notches on

the lower hinge supports, which should coincide with the

lower edge of the notches on the front side. When the door

is completely opened, remove the clips from the plugs of the

upper hinge supports and return them to horizontal position.

ﬁ gure 1

ﬁ gure 2

ﬁ gure 3

ﬁ gure 4