Operation Manual

134492

• Panels and furniture lining of the kitchen cabinet receiving

the hob must be treated with temperature resistant adhesives

(100°C), otherwise they might be discoloured or deformed

because of inadequate temperature resistance.

• Before installation you must remove the rear panel from the

kitchen cabinet in the area of installation.

• Follow the exact dimensions of the installation aperture,

indicated on the illustration.

• Bottom of the kitchen cabinet (max 530 mm) must always

be shorter than side panels in order to provide adequate

ventilation.

• Level the kitchen cabinet using the spirit level.

• Kitchen cabinet carrying the installed appliance must be ﬁ xed

to the adjacent cabinet to ensure adequate stability.

• Push the appliance into the cabinet so that screw guides

located in the oven frame holes stay on the cabinet side

panels. Be careful not to tighten the screws excessively

because you may damage the cabinet sides or the enamel of

the appliance.

Instalation for electric

oven