Operation Manual

134492

Removal and reinsertion of oven door

Open the door to the horizontal position. Pull the bottom hinge

supports upwards to the vertical position and lock them to the

latch of upper hinge support. Close the door halfway (see ﬁ g.)

and pull it out.

For reinserting the door repeat the procedure backwards.

Insert the door in half open position (at an angle of 60°) by

pushing them all the way in during opening. Be sure that the

notches on bottom hinge carriers ﬁ t exactly the oven ﬂ oor. Now

open the door completely, remove the hinge clamps from the

upper hinge latches and return them into the horizontal position.

The oven light bulb casing is under tension. Danger of

electric shock!

Before replacing the oven bulb switch off the cooker and cut it

from mains by removing the mains power fuse or disconnect the

protective device.

Other accessories

Oven grid, biscuit tray, etc. may be ordered from the service

center. When ordering please quote the code and the type or

model of the appliance.

Oven light bulb

Remember that the bulb is regarded as consumption material

and is not covered by the warranty.

The bulb for replacement should meet the following

speciﬁ cations:

Casing E 14, 230 V, 15 W, 300°C. Unscrew the glass cover by

turning it counter clockwise, and replace the bulb. Screw the

glass cover back in place. Side bulb glass cover is removed

by inserting the screwdriver into the notch and pulling it in the

direction of the arrow (see Fig.)

1 door hinge in operating

position

2 door hinge during

dismantling

Replacement of

components