Operation Manual

134492

• Never use aggressive cleaners, like polishing agents, dish

cleaning accessories, corrosion inhibitors, or any other devices

that might cause scratches.

• Coated, stainless steel or zinc-coated surfaces or aluminum

parts must not come into contact with oven sprays, since

they might cause damage or discoloration. The same goes

for thermostat probe (if the appliance is equipped with it) and

exposed heaters on the oven ceiling.

• When purchasing cleaning agents remember the environment,

and strictly follow the manufacturer’s instructions.

Helpful hint

• When roasting large greasy chunks of meat, wrap them in

aluminum foil or baking paper, to prevent grease spurting all

around the oven.

• When grilling, always place grease dripping pan below the grid

with meat.

Accessories

Accessories, like biscuit tray, oven grid, etc. are cleaned with hot

water and the usual detergent.

Special enamel:

Oven, interior door lining, baking tray and grease interception

pan are coated with special enamel, with smooth and resistant

surface.

This special coating facilitates cleaning at room temperature.

Grease ﬁ lter:

Clean the grease ﬁ lter after each use with soft brush in hot water

with some detergent, or wash it in the dishwasher.

Removing wire grids and telescopic guides

Telescopic guide grids or wire guides may be removed to

facilitate the cleaning of the oven. Side grids are removed by

swinging the bottom side inwards and unhooking them from

their place. Clean the side grids and telescopic guides only with

conventional detergents. Telescopic guides may not be washed

in a dishwasher. Note! Never lubricate the telescopic guides!

To reinsert, repeat the procedure backwards: slide them into the

holes and swing downwards.

Maintenance