Operation Manual

Registering ProScan
The ProScan software can be freely downloaded and installed from our web site, but the
diagnostic and analysis tools cannot be used on a vehicle until the software has been
purchased and registered.
When you purchase ProScan you will be issued a serial number that will unlock the
software and provide full functionality.
Registering ProScan is a simple, one-time-only process that will take only a few seconds
the first time you try connecting to a vehicle. To register, run the ProScan software and
click the Connect button within the Vehicle Connection Manager. If you haven’t
previously registered, you’ll be presented with the dialog shown below in Image 1.
Simply enter your assigned serial number and click the Register button.
Image 1: Registration Prompt
If you entered a valid serial number, you will receive confirmation that your software was
successfully registered. You will not be required to enter your serial number again unless
you re-install the software.
TIP
Store your serial number and
proof of purchase in a safe
place as you will need them to
upgrade your software in the
future.
7