User's Manual

We suggest use the adaptor specification at 5V/1A
When speaker with low battery capacity, please charge the speaker immediately
The speaker can be charged by different charging current, if using the computer to charge
the speaker, as the current only at 500 mA, the charging time will be very long.
Troubleshooting
1. What should I do if the speaker can not pair with the Bluetooth device and play
music accordingly?
(1) Please check the specification/ the manual of the Bluetooth device (your mobile or
computer), and check if the device can support the A2DP stereo audio transmission. If
yes, please turn on the A2DP stereo mode.
(2) Ensure the speaker is under the Bluetooth pairing status, if there are many
Bluetooth devices nearby, the G30 will not easy to be found. Please turn off other
Bluetooth devices.
2.What should I do if the speaker get stuck and all the button can notwork.
The speaker’s inner system may be wrong with some inappropriate operation. Please try
to long press the button and hold for 8 seconds to reset the speaker’s software.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could
void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. This equipment should be
installed and operated with minimum distance 0mm between the radiator & your body.
