User Manual

Step 1 : build the main fixed framework
For this you need part 1 (x4) and parts 2, 3, 4 and 5
Assembly parts 4 with parts 2 and 3
Then push them on two part 1 to form one slide of the framework. I recommend to use a very small
hammer with a wooden block to stick them in place with care. The holes have just the required size.
Add the part 5 between the two half side, then add the 2 others part 1 on top to form the other side.
Part 3 will receive the servo for moving the camera vertically, part 2 will receive the gear for
vertical movement.