Operation Manual

GoPro Studio 2.5 User Manual
Replacing Target Areas With Your Video Clips
With your video clips loaded in the Media Bin, you’re ready to start replacing GoPro Edit
Template content on the Storyboard using the following steps:
1. Select the desired clip in the Media Bin.
2. Move the Play-head on the Playback Slider to the desired start location of your
clip and press the MARK IN button to trim the beginning of the clip. The yellow IN
Point marker will move to this position on the Playback Slider indicating the new
start location. Don’t worry about the OUT Point as we will address that later.
3. Click and drag the clip to the Storyboard and drop it onto the Target Area you
wish to replace (a green box will highlight the Target Area indicating that an
approved clip replacement is about to occur).
4. Optionally, click the MUTE button on the clip’s thumbnail on the Storyboard to
disable sound from the video clip.
5. Press ‘Command+S’ to save your project.
6. Repeat these steps using the other video clips in your Media Bin (or different
portions of the same clip) until each Target Area on the Storyboard has been
replaced.
After a Target Area has been replaced, the “target” icon is removed and the thumbnail
changes to represent the first frame of your video clip. At any time during this process,
you can use the PLAY button to playback the Storyboard in the Player Window.
TIP: Dragging the same source clip from the Media Bin onto consecutive Target Areas
will result in the IN Point of the clip in the later Target Area to line up with the OUT Point
of the clip in the previous Target Area. This is a great way to use a larger portion of a clip
than a single Target Area will allow. NOTE: this only works if you do not manually change
the IN or OUT Points of the source clip in the Media Bin.
MARK IN Button
MARK OUT Button
41