Operation Manual

To combine cameras in 3D HERO System waterproof housing:

1. Open back door to the 3D housing.

2. Insert “right” camera right side up into housing.

3. Insert “le” camera upside down into housing.

4. I

nsert the 3D HERO Sync Cable into the HERO Bus

Port on both cameras. The side that says “R” on the

sync cable attaches to the right camera while side that

says “L” on the sync cable attaches to the le camera.

Note: Upon insertion of the sync cable, the right

camera will automatically set itself to be in UP mode

and the le camera will automatically set itself to

be in UPd mode. This conﬁguration is required for

capturing synchronized 3D videos and photos. If 3D

synchronization is not desired, you can manually

change each camera’s settings to be in a diﬀerent

UP/UPd mode, diﬀerent resolution, etc, but the

cameras will only record in a synchronized manner

allowing for 3D if BOTH cameras are set to shoot the

same resolution, record mode and frame rate.

5. Make sure the 3D Sync Cable is fully inserted

and is ﬂush against the back of the cameras.

Close waterhousing.

If settings are changed and you wish to return each camera

to its default 3D setting, simply unplug the sync cable and

then plug the sync cable back in to both cameras. This will

reset the right camera to UP mode (right side up) and the le

camera to UPd mode (upside down), allowing for synchronized

3D video and photo capture.

REMOVING 3D SYNC CABLE FROM CAMERAS

To remove the sync cable from the HD HERO Bus Port, grasp

each 3D sync port connector ﬁrmly and remove by liing

device evenly away from the HERO Bus Port. Do NOT pull on

cable connecting the le and right HERO port connectors.