UNITED KINGDOM CANADA RUSSIA GERMANY UNITED STATES FRANCE ITALY SPAIN JAPAN AUSTRALIA TIPS: Your suggestions and comments for Costway are really important to us! We sincerely solicit you to go back to our shop and leave a good rating in just a simple click.It would be quite encouraging if you could kindly do so like below: Great products so far February 24, 2018 Great product so far. Fast delivery, easy setup, and working without any issues.
Specifications Contents Before using Parts name............................ 1 Cautions............................... 2 Model EP23936 Rated voltage and frequency 120V~ 60Hz Rated capacity of wash and spin 10LBS (dry laundries weight) Water level/water volume（about） L/16L M/23L H/30L Inlet pressure 0.03MPa~0.85MPa Rated input power Wash：240W spin：210W Dimensions W429mm D433mm H747mm Installation and adjustment..... 4 How to use drainpipe.............. 5 Water inlet installation............
Other functions Parts name 1. Give an alarm Display Explanation Settlement Feed valve Top lid Top frame water level+wash+spin light flash After draining 5 minutes, it still does not reach to water level Open top lid, according to before troubleshooting and settlement to settle it, then close the top lid and clear up the alarm.
Cautions Please insert the plug into the power socket with rated voltage 120V A/C. Always unplug the appliance and turn off the water when the power is cut, or it is not in use, moving or cleaning the washing machine. Do not insert or pull off the plug with wet hand. Settlement Earth wire Do not make the electric cable bended, stretched, twisted, strapped or changed, pressed or nipped.
Troubleshooting Cautions Before contacting the technicians, please make the following checks: Possible reason Phenomena Control panel has no any display Inlet hose leaks Do not put hands into the working machine. It is dangerous even if the speed is very slow. Take special care of the children, and forbid them to climb on the washing machine. It is dangerous to alter the specifications or attempt to modify this product in any way.
Installation and adjustment Maintenance Please install and adjust the machine according to the requirements of the manual. It is very important to your safety and correct operation. Maintenance methods Unpacking After the end of the programme Unpack the carton and take out the bottom panel. The machine stops automatically, and music buzzer will remind you to take out the laundries or start again.
Operation steps How to use drainpipe 1. Press power switch, put through power, the machine is in state of beginning: 2. Press “program”button to begin program selection. 3. Select appropriate water level according to your laundries quantity. 4. Close the top lid, press Start/Pause, the washing machine is working. 5. When the washing is finished, buzzer alarm, power supply cut off automatically. Less than 4ft 1.
Water inlet installation 0.4 To control the washing machine is in working state or waiting state. in 0.4in Check the connection between inlet hose connector and the tap POWER 1. Swing the inlet hose gently to confirm if it is fastened. 2. After installation, open the tap and check if it leaks. 3. Do not bend the inlet hose with overstrain. 4. Before each usage, check the connection between inlet hose connector and the tap.
Preparation before operation Control panel instruction Mode and meaning of the indicator light on: indicate the selected mode flashing: indicate the program is running [Normal] Commonly used procedures in the main routine general washing clothes. [Standard] The standard procedure, required by the general washing dirty clothes often changed. [Fast] Fast is not too dirty for washing clothes, washing shorter time. [Underwear] For personal clothing washing underwear, clothing to be gentle when wasing.
Use of detergent Load laundries The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition. Washing quantity shall be lower than the rated capacity. Different thickness, size and type of the laundries will influence the actual washing capacity. It is suitable that the laundries can be turned round normally during washing. Don't select high water level when laundries are less than 2.2LBS to avoid water splashing.
