User Manual

WaveAce

WA-GSM-E-RevA

PLEASE NOTE THE FOLLOWING:

The design of the instrument has been verified to conform to EN 61010-1

safety standard per the following limits:

 Installation (Overvoltage) Categories II (Mains Supply Connector) & I

(Measuring Terminals)

 Pollution Degree 2

 Protection Class I

Cooling

The instrument relies on forced air cooling with internal fans and ventilation

openings. Care must be taken to avoid restricting the airflow around the

apertures (fan holes) at the sides and rear of the oscilloscope. Ensure

adequate ventilation by leaving the required 10 cm (4 inch) minimum gap

around the sides and rear of the instrument.

CAUTION

Do not block the ventilation holes located on both sides and rear of the

oscilloscope.

CAUTION

Do not allow any foreign matter to enter the oscilloscope through the

ventilation holes, etc.

AC Power Source

100 to 240 Vrms (+/-10%) AC at 50/60/400 Hz; Installation Category: 300V

CAT II

No manual voltage selection is required because the instrument

automatically adapts to line voltage.

Maximum Power Consumption: 50 VA

Note: The instrument automatically adapts itself to the AC line input within

the following ranges:

Voltage

Range:

90 to 264 VAC

Frequency

Range:

45 to 440 Hz