User Manual

WaveAce

WA-GSM-E-RevA

Slope Triggering

Use Slope Triggering to trigger on the positive slope or negative slope

depending on the trigger conditions and time you set.

1. Press the Type option button and select Slope.

2. Press the Source option button to choose a

channel input or external input.

3. Press the When option button to select the

trigger condition.

4. Press the Time option button and then turn the

Adjust front panel knob to set the slope time.

5. Press the Next Page option button.

6. Press the Vertical option button and select the

trigger level that can be adjusted using the

Level front panel knob. You can adjust Level A,

Level B, or adjust both at the same time.

7. Press the Mode option button to select Auto,

Normal, or Single mode. Use Auto mode to let

the acquisition automatically run in the absence

of a trigger. Use Normal mode when you want

to see only valid triggered waveforms (when

you use this mode the oscilloscope does not

display a waveform until after the first trigger).

Use Single mode when you want the

oscilloscope to acquire a single waveform.

8. Press the Setup option button to display the

Trigger Setup menu. You can use the Trigger

Setup menu to select a coupling mode and

define a Holdoff value. Coupling modes

comprise DC, AC, HF Reject, and LF Reject.

Turn the Adjust front panel knob to set the

Holdoff value.